cavity wall

英 [ˌkævəti ˈwɔːl]

美 [ˌkævəti ˈwɔːl]

n.  (有保暖作用的)空心墙，夹壁墙

医学

牛津词典

noun

• （有保暖作用的）空心墙，夹壁墙
  a wall consisting of two walls with a space between them, designed to prevent heat from escaping
  1. cavity wall insulation
     空心墙隔热

柯林斯词典

• N-COUNT (隔音或防寒的)空心墙，夹层墙
  Acavity wallis a wall that consists of two separate walls with a space between them. Cavity walls help to keep out noise and cold.
  1. ...cavity wall insulation.
     空心墙隔音材料

英英释义

noun

• a wall formed of two thicknesses of masonry with a space between them

双语例句

• As a special masonry structure, cavity wall masonry is well accepted in rural areas of our country due to its low cost.
  空斗墙砌体作为一种特殊的砌体结构，由于其造价低廉，我国很多农村地区建房都采用这种结构。
• The three main problems faced by water pump are leakage, vibration noise and corrosion of the impeller and water cavity wall.
  汽车水泵的三个主要故障是泄漏、振动噪声和叶轮或水腔内的腐蚀。
• Discussion on the calculation formulas of injection mold cavity wall thickness
  注塑模型腔壁厚计算公式讨论
• According to theories and experiments, this paper test condensation phenomenon of cavity wall.
  理论和试验相结合对夹芯墙体的冷凝现象进行了检验。
• This numerical simulation on gas penetration, pressure field, displacement process of melt-gas boundary in different time, and skin melt forming on the cavity wall is developed for GAIM parts.
  该研究对气体的穿透过程、压力场分布、小同时刻熔体/气体边界的移动状态以及在模壁上形成表层聚合物熔体壁厚的过程进行了气体辅助注射成形充模流动的实例数值模拟研究。
• A ( test): after being eroded through acid, the cavity wall was spread with EM dental adhesive, then filled with silver amalgam.
  A组：经酸蚀后在洞壁周围涂以薄层EM粘结剂，吹匀随即以银汞合金充填。
• Analysis of stress paths in clays adjacent to cavity wall during self-boring pressuremeter tests
  自钻式旁压试验中邻近腔壁土的应力路径分析
• Influence of cavity wall elasticity on resonant frequency of small underwater cylindrical Helmholtz resonator
  腔壁弹性对水下小型圆柱形亥姆霍兹共振器共振频率的影响
• Restoring force of small concrete hollow block cavity wall
  混凝土小型空心砌块空腔墙体的恢复力试验研究
• Aiming at the injection mold structures of female mold on stationary mold, the force on the famale mold and male mold are analysed, and the cavity wall thickness are calculated.
  针对凹模安装在定模上、凸模安装在动模上的注塑模结构，对矩形型腔模具进行了受力分析和型腔壁厚计算。